Q. How do I set up an output to trigger when one of my security sensors is tripped?

In order to activate a relay you will first wire your accessory ( strobe, siren, audible alarm) to one of the outputs on your Siren 3 plus or pro. This would be the white or purple wire on harness 1 and the white or blue wires on harness 2.
Once you have wired the audible alarm, you will check the settings in your mobile app.
This can be done by following these steps:

1. Arm your device by clicking “arm” in the bottom right hand corner of where your boat picture is displayed.
2. Click the Siren tab.
3. Click directly into your security sensor tile.
4. Click the settings wheel in the top right hand corner.
5. Under Output Settings select the 3 dot kabob menu option.
6. Turn on the associated output.
7. Lastly, set a run time.
   *If you do not set a run time the audible alarm will run continuously.

Once setting up the parameters in the app your output should now go off whenever the associated sensor is triggered. You can also turn on the outputs simply by going to the commands page of your mobile app to turn things on/off.
Arming/disarming the device via the mobile app will not turn an output on or off!